3F UL Gear

How to Pitch a Lanshan 2: Step-by-Step

Quick answer

Pitch the Lanshan 2 as a rectangle first: stake one corner, set the adjacent short side, find the opposite short side, then insert two trekking poles set to about 125 cm. Get the base square before you tension the fly; overtightening a crooked base is the most common mistake.

Lanshan 2 pitch

What you need

  • Lanshan 2 tent and inner (attached or separate, depending on model)
  • Two trekking poles, set to about 125 cm
  • 9 stakes and 4 wind ropes (included)
  • Flat, well-drained ground; avoid a hollow where water collects

Step 1: stake the first short side

Lay the fly out and stake the two corners of one short side. Keep the line slightly loose; you are setting the width of the base, not tensioning the tent. If the ground is hard, start the stakes at an angle and do not force them.

Step 2: complete the rectangle

Walk to the opposite short side and stake its two corners so the base forms a rectangle. Check the two diagonals: if they are not roughly equal, move a corner until they are. A square base is what lets the poles stand vertically; do this before you insert the poles.

Step 3: insert the poles

Set both trekking poles to about 125 cm — the official 3F UL guide uses 125 cm as the target peak height. Insert the pole tips into the grommets or pockets, then stand the poles upright. If a pole will not stand vertically, the base is probably too long: move a short-side stake 5–10 cm inward and try again.

Step 4: tension the fly

Tension the fly gradually. The fly should be taut but not drum-tight. Check that the fly is not touching the inner; if it is, adjust the pole height or the corner stakes. A fly that touches the inner transfers condensation to the inner.

Step 5: vestibules and guy lines

Stake out the vestibules, then the guy lines. The corner stake cords should line up with the side ridgeline; if they pull sideways, the stake can lift in wind. Do not overtighten the side guy lines — it distorts the tent and can damage the fabric.

Common mistakes

  • Pitching a diamond, not a rectangle. The base must be square before you tension anything.
  • Poles too tall. If the pole will not stand vertically, shorten the base, not the pole.
  • Overtightening. Nylon stretches; brute force can stretch needle holes.
  • Fly touching the inner. Adjust the pole or corner stakes.
  • Ignoring wind direction. Pitch the low end into the wind and use the guy lines.

How long does it take?

First pitch: 10–15 minutes. With practice: 5–8 minutes. In wind, stake one corner before you unfold the tent, and keep the fly low until the poles are in.

FAQ

What pole length does the Lanshan 2 use? Around 125 cm. Check the current product page for your variant; the official guide targets a 125 cm peak.

Is the Lanshan 2 freestanding? No. It needs two trekking poles and stakes.

Can I pitch it in wind? Yes, but stake one corner first, keep the fly low, and use all guy lines. Do not let the tent flap while you insert the poles.

前後の記事を読む

コメントを書く

このサイトはhCaptchaによって保護されており、hCaptchaプライバシーポリシーおよび利用規約が適用されます。